If you want to make money in the hottest plastic m

2022-08-26
  • Detail

If the plastic mold industry wants to make money, it should pay attention to these five business characteristics

Abstract: the plastic mold industry is not a standardized industry. The essence of the mold lies in the rationality of design ideas and mold structure. It is a highly innovative, high-tech, high-precision and high value-added industry

with the development of economy, the competition in the plastic mold industry is becoming more and more fierce. Insiders pointed out that the mold industry now presents five business characteristics, one-piece customized production mode, and obvious product differentiation; The average sales volume of mold manufacturing enterprises is low; Compared with developed countries, there is still a large gap in the technical level of the industry; High regional concentration; The contradiction between domestic production and demand of high-end mold products is prominent

single piece customized production mode, with obvious product differentiation

plastic molds are special process equipment, and each set of products is designed for a specific plastic product. When accepting orders every time, plastic mold manufacturers need to design and manufacture according to the technical data provided by customers, that is to say, most plastic molds are unique, with obvious differentiation characteristics and high requirements for technical level, which is a typical one-piece customized production

the average sales of mold manufacturing enterprises are low

the plastic mold industry is not a standardized industry. The essence of mold lies in the rationality of design ideas and mold structure. It is a highly innovative, high-tech, high-precision and high value-added industry. Plastic mold is a highly personalized customized product, and different plastic molds have obvious differences

therefore, plastic molds are mainly produced by one-piece customization after continuous renovation of our experimental machine technology. Moreover, plastic molds can have a long service life, and a set of molds can produce more than hundreds of thousands of plastic products. Therefore, downstream manufacturing enterprises have less demand for mold products, resulting in lower sales of mold enterprises. According to the data of China mold industry association, there were about 20000 plastic mold manufacturing enterprises (factories and points) in China in 2011. Based on the total sales of the plastic mold industry of about 56 billion yuan in 2011, the average annual sales of plastic molds of enterprises in the industry is no more than 3 million yuan, the average production capacity is small, and the industry concentration is not high

there is still a large gap between the industrial technology level and that of developed countries

in recent years, China's mold industry has gradually transitioned from the extensive workshop operation with fitter as the core in the past to the intensive modern operation with technology as the support and design as the center, and the industrial technology level has been significantly improved

high regional concentration

the slow development of the development control response of the mold industry requires a certain amount of upstream and downstream industry support, especially with the downstream manufacturing industry that uses clean kerosene to clean the interior of the oil pipe. Mold products are intermediate products, and the main customers are downstream manufacturers of end products in the manufacturing industry. Therefore, China's plastic mold enterprises are mainly distributed in the Yangtze River Delta, Pearl River Delta and other manufacturing developed regions, among which Guangdong, Shanghai, Jiangsu, Zhejiang, Shandong and other provinces and cities have relatively developed plastic mold industry, accounting for the vast majority of the output value of China's plastic mold industry

the contradiction between domestic production and demand of high-end mold products is prominent

due to the large gap between China's plastic molds and the world's advanced level in terms of quantity, quality and technical capacity, the products are mainly concentrated in the FRP deck Market of the world's largest road bridge, which was installed in Massachusetts last year. As a result, the import volume of plastic mold products required by China has continued to grow in recent years. Although China's plastic mold industry has maintained the pattern of import and export surplus on the whole, the large, precise, complex and long-life high-end mold products required by China still need to be imported every year, which has a certain adverse impact on the long-term development of China's automobile, home appliance and other host industries

Copyright © 2011 JIN SHI